EZ Freeze Gas Refrigerators
The official site for EZ FREEZE Propane Refrigerators and Natural Gas Refrigerators - Including Blizzard Gas Freezers
EZ Freeze Size Chart
EZ Freeze Features
EZ Freeze Dealers
EZ Freeze Service
Contact EZ Freeze
 

Gas Refrigerator Freezer Combination Units 

EZ Freeze EZ-10 Propane Gas Fridge
Gas Refrigerator EZ-15W
Gas Refrigerator EZ-15B
Gas Refrigerator EZ-15SS
Gas Refrigerator EZ-19W
Gas Refrigerator EZ-19Q
Gas Refrigerator EZ-19B
Gas Refrigerator EZ-19SS
Gas Refrigerator EZ-21W
Gas Refrigerator EZ-21B
Gas Refrigerator EZ-21SS
EZ-15W
EZ-15B
EZ-15SS
EZ-19W
EZ-19Q
EZ-19B
EZ-19SS
EZ-21W
EZ-21B
EZ-21SS
 
   

Upright Gas Freezers

 

Total Gas Refrigerator

     
   
Blizzard 15 Cu. Ct. Upright Propane Freezer
Blizzard propane freezer
Blizzard large upright propane freezer
EZ Freeze 21 Cu. Ct. Total Refrigerator
     
   
BF-15UF
BF-18UF
 BF-22UF
EZ-21R
     

 

Lighting a gas refrigerator

First Time....
After the set-up of the unit is complete, use the following procedure to light the burner. First time lighting may take longer than usual due to the air that may be in the gas lines.

  1. Turn on the gas valve at the rear of the refrigerator
  2. To start the refrigerator, turn the thermostat knob "Temp" (Thermostat) to the #2 setting
  3. Push and hold "Gas" (Gas Safety Valve) button, and then...
  4. Press the "Spark " (Piezo Ignitor) button continuously 5 to 10 times to light burner. Confirm the flame is lit by viewing through the flame "Viewer". It should be possible to hear a slight turbulent noise from the flame. If the burner is lit, continue holding the "Gas " button for 5-15 seconds. Release the "Gas" button and confirm the burner is still lit. If the burner does not light, repeat steps 1 through 4.

We recommend to take a good look at the flame upon initial start up and memorize the size and color for future reference. It is good practice to visually check the flame for this size and color upon every start up. If the flame is too small or discolored, refer to the trouble shooting section.

Hand Lighting....
If for some reason the unit will not light with the piezo ignition or the ignitor is failing to spark, it is possible to hand light the burner. This usually requires two people. Simply use the above procedure and replace "Spark " Button with a person at the burner with a lighter. Refer to the Will not Light section.

 

copyright © EZ Freeze 2016
Specifications listed subject to modification, improvement, or change without notice.